Do you want to replace your bathtub? Are you having a chip and crack bathtub? Are you looking for an easy process?
Bathtub replacing is not good idea. If you have a bad bathtub or crack, you do not need to replace bathtub to save money. There are easy ways you can try for your bad bathtub.
If you having a crack or chips bathtub, trying to do not substitute with a new bathtub. You can make a new look from previously with bathtub refinishing. This is a cost effective bathroom makeover alternative you can try with your bathtub. The bathtub refinishing is alternative to replacing a bathtub that is damaged; get the wrong color, worn out and hard to clean.
In refinishing to look as new bathtub you can ask the hire professional to help you or you can going to do it yourself. The bathtub replacing with bathtub refinishing is different ways. The bathtubs replaced are tending more difficult because you should substitute with a new bathtub. If you want to ask the hire professional it is just depending on you. It is a good idea to save your money; to do it yourself if you have an experience in bathroom refinishing because it is not too much sweats drain.
In this case, we will share about Bathtub Refinishing to help you when begin the refinishing. We allow you to follow the easy process for your bathtub. Hopefully, this instruction is helpful for you. So, check below
- Prepare the tools and material
The first thing you have to do is preparing the material and tools such as;
–Â Â Â Â Â Â Â Â Â Materials: masking tape, masking paper bulk, plastic masking bulk, precision masking tape, sandpaper and masking machine
–Â Â Â Â Â Â Â Â Â Tools: wall tent system, tile grout, bondo spreaders, safety scraper large, razor scraper small, internal wrench for bath drains, dumbbell wrench for drains and sponges.
Make sure you have bathtubs hardware material for all your refinishing needs.
- Clean and scraping the surface
Clean any anti slip strips with specially formulated such as a body oils, mineral deposits, cleanser and degreaser.
- Etching the surface and clean after etching
- Chip repair: Fill chips or defects and sand the tub smooth
Give sand meant for when you rough up the surface, it will give you good adhesion for coating and removing any grime or gloss.
- Masking and taping
Prepare the masking tape, masking paper bulk, plastic masking bulk, and masking machine.
- Final preparing the surface for reglazing
Masking your entire bathroom such as walls and flooring with masking tape, masking paper bulk, plastic masking bulk. To cut masking paper bulk uses the masking machine
- Surface primer and reglazing
Give the surface primer for based reglazing.
We are almost done. Start to give apply reglazing with the color that you want. And wait around 3 hours or more.
- Now enjoy your new bathtub
So, what are you waiting for? Letâ€™s follow these easy steps and make your bathtub a new look and new condition.